Water Softener For Dishwashers & Glasswashers 8 litre - WS8-SK

CONNECTION TO THE WATER MAINS (Refer to Fig 1)
• The user must install a tap between the water mains and the water softener so that the water can
be turned off in an emergency, plus a check valve to avoid any pressure returns.
• Connect the water inlet and outlet hoses to the water softener and make sure these are tightened
properly.
• Place the drain hose directly in a drain.

COMMISSIONING
Rinsing of resins (Refer to Fig 2) Place the outlet hose in a drain.
Turn the taps levers to the left and open the water inlet; let the water flow until clear, then stop the inlet water and connect the outlet hose to the machine to be supplied.

Routine Regeneration (Refer to Fig 3)
• Place the depression hose in a bucket. Turn the taps levers to the right and
wait for the pressure to drop. Remove the cover by unscrewing the knob and
then add the salt in the amount indicated to suit the model (see table 1).
• WARNING: Remove any salt from the seal on the cover.

Regeneration Mode (Refer to Fig 4)
• Replace the cover and tighten the knob securely, then move the inlet tap
lever to the left.
• WARNING: Remove any salt from the top of the water softener.
• Let the salty water flow from the drain hose until the water is soft (about 40
minutes).

Normal Operating Mode
• Return the water softener to normal working conditions by turning the outlet
tap lever to the left.
• Regeneration completed.
• WARNING: the equipment connected to the water softener is not
supplied during regeneration.

To ensure the efficiency of the water softener at all times, we recommend routine
regeneration to suit the use made of the water softener and the hardness of the water used.